Fills but won't agitate
The washer fills but the agitator doesn't move. Usually the motor coupler has worn through or the belt has snapped. Once the drive is tested and the part replaced, a full cycle proves it agitates and spins again.
Amana washers, dryers, refrigerators, ranges and freezers repaired across Lake County, with a straight answer on whether the repair is worth it.
Amana appliances are common in Lake County rentals, starter homes and basements: basic top-load washers and dryers, top-freezer refrigerators, electric and gas ranges and chest freezers bought for their price and simplicity. Those chest freezers are some of the cheapest freezer repair jobs we do.
Simplicity cuts both ways. Most Amana machines have few or no error codes, so the appliance can't tell you what failed. The diagnosis depends on testing switches, valves and heaters one at a time, which is exactly what we do.
An Amana visit opens with a $75 diagnosis, and the fee is applied to the repair if you go ahead. Landlords can approve by phone at (224) 778-9765; anyone can book online.

Amana came under Whirlpool along with Maytag in 2006, and its laundry now borrows much of its design and many parts from both. That keeps parts affordable and available, and the stock we carry for Whirlpool washer repair often fits an Amana too. What Amana usually lacks is a detailed display. Instead of reading a code, we run the cycle, watch where it stops and test each component in that step.
On a washer that fills but won't agitate, that means checking the lid switch, the coupler and the drive. That kind of washer repair is usually finished in one visit. On a dryer that tumbles without heat, it means the thermal fuse, the element or the gas valve. On a refrigerator that warms, it means the defrost heater, thermostat and fan.
Because Amana appliances are inexpensive to buy, the repair-or-replace question matters. A switch, fuse or belt is always worth replacing. A compressor or transmission on an older unit often isn't. We give you both numbers and let you decide.
An Amana rarely tells you what failed, so the decision rests on what our tests find and what the part costs against the machine's age.

We find the failed part by testing each step, not reading a code.

Switches, fuses and belts are cheap; major parts may not be worth it.

Older budget machines get an honest repair-or-replace answer.
Most Amana calls are laundry, but the kitchen units fail in their own simple ways.
All services
Top-load washers that won't agitate, spin or drain, usually from a lid switch, coupler, belt or pump.
Basic electric and gas dryers that tumble cold or thump on a worn roller.
Top-freezer and side-by-side models with a dead defrost heater, a frosted coil or a drip under the drawers.
Electric ranges with burned elements and gas ranges with weak igniters.
Basement chest freezers with a tired gasket or a thermostat that has stopped cycling.
Over-the-range units in rentals that light up and spin but never heat.
None of these six needs an error code to find.
The washer fills but the agitator doesn't move. Usually the motor coupler has worn through or the belt has snapped. Once the drive is tested and the part replaced, a full cycle proves it agitates and spins again.
The washer does nothing when you press start and shows no code. A failed lid switch or timer contact is usually responsible. We test both, replace the failed one and check the wiring at the lid.
The drum spins, the timer advances, and the load comes out wet. A blown thermal fuse is common, often caused by a clogged vent. We replace the fuse or element, test the thermostats and check the vent airflow so it doesn't blow again.
Frost builds on the back wall of the freezer and the refrigerator warms. The defrost heater, thermostat or timer has failed. After a manual defrost we meter the heater, thermostat and timer and swap the one that is open.
One coil burner on the electric range won't heat. The burner, its receptacle or the infinite switch has failed. We test each, replace the faulty part and check the other burners.
A chest freezer in the basement or garage won't hold temperature. A worn gasket, failed thermostat or frost buildup is typical. We test and repair it and advise on using it in a cold garage.
Amana repairs are usually quick and inexpensive. We tell you plainly when they aren't. The same goes for Maytag appliance repair, since the two brands share so many parts.

Tell us at which point the cycle quits: filling, agitating, spinning or drying.
It is usually under the lid or on the back panel. A photo works.
We run the machine, watch where it stops and meter the parts used in that step. The $75 counts toward the repair.
You get the repair price and our honest view of replacing it instead.
We repeat the cycle that failed, start to finish, before we leave.
Service areaMany of our Amana calls come from rentals and starter homes in the towns below. If you found us by searching appliance repair near me, the same van covers the rest of Lake County too.
Amana joined Whirlpool along with Maytag, so parts overlap.
Many Amana machines show none, so we test each step.
We find the failed part even without error codes.
We tell you when an Amana isn't worth repairing.
Owners get the estimate; tenants get a time window.
Call with the symptom first. If the likely part costs more than the machine is worth, we will tell you before we come.
(224) 778-9765Usually, if the failed part is a switch, coupler, belt, fuse or pump. If a transmission or motor has failed on an older machine, replacement may cost about the same, and we'll tell you.
We run the cycle, see where it stops and test each component used in that step with a meter. It's slower than reading a code, but it finds the real cause.
Rarely. Amana belongs to Whirlpool Corporation and shares many parts with Whirlpool and Maytag, which keeps them easy to find.
Yes. Landlords can approve repairs by phone, and we arrange access with the tenant.
Usually the defrost system has failed: the heater, thermostat or timer. Frost then blocks airflow to the refrigerator section.
Yes, the $75 pays for the diagnosis itself. Go ahead with the repair and it is credited to the bill; decline, and that is the whole charge.
Call and a real person answers, or send the form and we'll call you back within 30 minutes during business hours.
Call now